Savage_Rob
Serious Thumper Alliance Member
Offline
Mechanically Inclined Amateur
Posts: 6972
Texas (Dallas area)
Gender:
|
Have you removed the valve/head cover yet? The reason I ask is that when I broke one off I was pretty dismal about it until after I removed the cover. There was actually about 1mm of the bolt visible above the edge of the block. I was able to barely grip it with a set of needle-nose vise-grips and turn it very slightly, adjust the grip, and turn again... (lather, rinse, repeat) until it was almost 1/4 inch up and then I could turn it with my fingers. Otherwise, it would have been drill and EZ-out time for me. Good luck!
|