SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> The Marketplace >> Kawasaki 25T front pulley
/cgi-bin/YaBB.pl?num=1686226846

Message started by Armen on 06/08/23 at 05:20:46

Title: Kawasaki 25T front pulley
Post by Armen on 06/08/23 at 05:20:46

I’ve got a few of the modified Kawasaki 25T front pulleys ready to ship.
Modified pulley, 2 button head stainless Allen screws, and a new lock tab.
This will lower your highway revs and make the bike sound more relaxed.
There is enough room in the adjuster to move the wheel forward and have adequate belt slack.
Really terrific write-up somewhere in the tech section.
Basically, remove the original front pulley, do a little grinding, and install the new stuff. Anti-seize on the splines, Loctite on the threads, torque the big honking nut, adjust the belt, and put the cover back on.
Not much more than that.
$160 with shipping in the USA.
Shoot me a note with questions.
Thanks,
Armen
For some reason, I can’t post a pic. Maybe I have to dumb down the size.
I’ll try again later.

Title: Re: Kawasaki 27T front pulley
Post by badwolf on 06/08/23 at 07:30:29

27 tooth?

Title: Re: Kawasaki 25T front pulley
Post by Armen on 06/08/23 at 07:32:28

I think so.
2 more than stock.

Title: Re: Kawasaki 27T front pulley
Post by Gus on 06/14/23 at 07:50:39

Daves write up says stock is 23 tooth & the Kawa pulley is 25. I have one lying on my desk in front of me, I just counted the teeth and its 25 for sure.

Title: Re: Kawasaki 27T front pulley
Post by Armen on 06/14/23 at 07:52:16

Oops. My bad. It’s been a while since I counted them. Two more than stock :-)

Title: Re: Kawasaki 25T front pulley
Post by Armen on 06/15/23 at 15:01:11

Stock pulley and modified Kawasaki pulley.
Stock is 23 teeth, Kawi is 25.
This comes with a new lock tab thingie, and two stainless button head allen bolts.