SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> '96 Paint and body...
/cgi-bin/YaBB.pl?num=1611215123

Message started by Mazdog on 01/20/21 at 23:45:23

Title: '96 Paint and body...
Post by Mazdog on 01/20/21 at 23:45:23

I've always been bad at keeping a photo record of my projects...but here goes. It's still far from finished but I think it's coming along. I'll try to post more pics as I go...

http://https://i.postimg.cc/bYVYNgDV/P1010789-1600.jpg

http://https://i.postimg.cc/W15cXbGW/P1010832-1600.jpg

http://https://i.postimg.cc/v8nMbyyT/P1010827-1600.jpg

http://https://i.postimg.cc/6pm187LX/P1020022-1600.jpg

http://https://i.postimg.cc/0jnVPr2h/P1020028-1600.jpg

http://https://i.postimg.cc/xjv761Yv/P1020023-1600.jpg

http://https://i.postimg.cc/6qJky7K3/P1010842-1600.jpg

http://https://i.postimg.cc/j24F2Zvg/P1020012-1600.jpg

Title: Re: '96 Paint and body...
Post by Mazdog on 01/20/21 at 23:58:37

Here's tonight's project...Also put some awesome rockin' 3D silver Suzuki decals from ChinaBay.

http://https://i.postimg.cc/xCRCRSd9/P1020043-1600.jpg

http://https://i.postimg.cc/x1wcjR7V/P1020040-1600.jpg

http://https://i.postimg.cc/NfPKSYkM/P1020037-1600.jpg

http://https://i.postimg.cc/Dyt21zcq/P1020055-1600.jpg

Title: Re: '96 Paint and body...
Post by Dave on 01/21/21 at 04:17:06

Looks good!

That small LED tail light will be woefully inadequate.

I had a similar one on my Cafe' build, and in sunlight and daylight it is not visible......nobody in their car/truck will see your brake light come on. While it may appear adequate in your garage or driveway when you are looking directly at it - when it is out on the street in traffic it will not get the attention of distracted drivers.

I added a red emergency flasher module that can emit light steady without flashing as a brake light - it is far more visible. It is very bright and I put some red electrical tape on the lens to limit the brightness a bit so it is not overly bright and blinding people after dark - you could also use an electrical resistor.

I used this light for a brake light:
https://www.strobesnmore.com/StrobesNMore-E6-LED-Lighthead.html