SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> The Marketplace >> Cylinder Head.....ready to bolt on
/cgi-bin/YaBB.pl?num=1604066760

Message started by Dave on 10/30/20 at 07:05:57

Title: Cylinder Head.....ready to bolt on
Post by Dave on 10/30/20 at 07:05:57

I took an entire day and got this cylinder head ready to bolt on. The cylinder head was pressure washed to remove all grease/oil, the valves were removed and cleaned. Then I opened up the exhaust port to the "D" shape that DragBikeMike found to be the best for flow. All gasket surfaces were cleaned and check for flatness, new Viton valve stems seals were installed. The rockers are WebCam hardweld - one is new and one have a few thousand miles on it from my bike. I will be installing a new oil seal on the decompression shaft as soon as it arrives.

The price without a cam and shipped to anywhere in the mainland 48 states is $380....cheaper than you can buy a dirty head off eBay. (You are buying a head and an entire day of my labor). If you want a cam add $150 for a stock cam. I also have some performance cams that are new from Lancer. The performance cams are $299 from me or you can get one directly from Lancer.....with a $100 core charge until you send back a usable core.

The head and head cover is in really good shape - the head cover was bead blasted and has a new coat of ceramic engine paint.

Title: Re: Cylinder Head.....ready to bolt on
Post by Dave on 10/30/20 at 07:14:15

Ports and head prior to installing valves.

Title: Re: Cylinder Head.....ready to bolt on
Post by Dave on 10/30/20 at 07:15:16

Head with new Viton oil seals.

Title: Re: Cylinder Head.....ready to bolt on
Post by Dave on 10/30/20 at 07:16:25

Head with valves and springs installed.

Title: Re: Cylinder Head.....ready to bolt on
Post by Dave on 10/30/20 at 07:17:09

Head cover showing cam bearings and rockers.

Title: Re: Cylinder Head.....ready to bolt on
Post by Dave on 10/30/20 at 07:17:58

Head cover bottom side.

Title: Re: Cylinder Head.....ready to bolt on
Post by Dave on 10/30/20 at 07:19:37

Exhaust port with larger "D" shape opening.

(Note small crack in fin above exhaust port. The fin is not bent or broken and just has a crack).

Title: Re: Cylinder Head.....ready to bolt on
Post by Dave on 10/30/20 at 07:20:31

Additional photo of fin crack.

Title: Re: Cylinder Head.....ready to bolt on
Post by Dave on 10/30/20 at 07:21:23

Bottom of head with valves installed.

Title: Re: Cylinder Head.....ready to bolt on
Post by Dave on 10/30/20 at 07:22:36

Compete head assembly.

Decompression release will be completed when the seal arrives.

Title: Re: Cylinder Head.....ready to bolt on
Post by Dave on 10/31/20 at 08:10:09

Another view of completed head.

Title: Re: Cylinder Head.....ready to bolt on
Post by LANCER on 11/01/20 at 12:01:45

Blasting and painting makes it prettier !

Title: Re: Cylinder Head.....ready to bolt on
Post by Dave on 11/03/20 at 18:04:06

7F727D7076612124130 wrote:

Blasting and painting makes it prettier !

Yep.....I updated the photos to include the finished product.