SuzukiSavage.com /cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Jetting /cgi-bin/YaBB.pl?num=1577881962 Message started by LANCER on 01/01/20 at 04:32:42

Title: Jetting Post by LANCER on 01/01/20 at 04:32:42 Someone sent me a question about the jetting on my carb but I cannot remember or find who that person is, so if that is you please post here. I am running a 22.5 pilot and a 190 main jet , with the needle clip on the middle (3rd) notch.  (36mm VM with UFO, INT-J & QFTW) Thanks

Title: Re: Jetting Post by hotrod on 01/02/20 at 11:07:13 LANCER, On your carb settings, did you have to drill a hole in the needle jet,  or solder the pilot jet shut ?  The only way I got mine to idle right was to drill the needle jet. I'm using a pod air filter .

Title: Re: Jetting Post by LANCER on 01/02/20 at 12:21:57 517874747C6B28190 wrote: LANCER, On your carb settings, did you have to drill a hole in the needle jet,  or solder the pilot jet shut ?  The only way I got mine to idle right was to drill the needle jet. I'm using a pod air filter . So are you the person who ask me? Yes, I drill the needle jet hood with a 3/32” bit. I get better results by not soldering a pilot jet, but jetting normally.   A filter change can be beneficial if a good one is chosen.  Did you see the thread on air filter comparison tests ?  Good stuff.

SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved.