SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Throttle housing, aftermarket? /cgi-bin/YaBB.pl?num=1565831350 Message started by Tacopimp on 08/14/19 at 18:09:10 |
Title: Throttle housing, aftermarket? Post by Tacopimp on 08/14/19 at 18:09:10 Has anyone found a throttle housing that will work with our stock cable? The one I ordered didn't work because I couldn't get the throttle cable through the hole on the housing since the little piece on the end of the cable wouldn't fit through the hole. :( |
Title: Re: Throttle housing, aftermarket? Post by justin_o_guy2 on 08/14/19 at 23:30:55 I've never messed with that, but maybe you are supposed to pull the cable off the bike and thread it through that hole. |
Title: Re: Throttle housing, aftermarket? Post by Tacopimp on 08/15/19 at 05:26:16 5B444245585F6E5E6E56444803310 wrote:
Not sure what you mean, the little tiny barrel thing at the end of the cable is soldered onto the end of the cable. |
Title: Re: Throttle housing, aftermarket? Post by justin_o_guy2 on 08/15/19 at 05:36:46 What's on the other end? Maybe take the whole cable off the bike, poke it thru the hole, and run it back to the carburetor? |
Title: Re: Throttle housing, aftermarket? Post by ZSteele on 08/15/19 at 10:02:42 I drilled the hole on my aftermarket housing to accept the stock cable. I would not recommend doing this as the throttle now can be pushed forward and get stuck, not a problem if you know its there but you can't push your weight into the throttle. Building new cables isn't that hard, I'd suggest just doing it the right way [ch128521] |
Title: Re: Throttle housing, aftermarket? Post by Tacopimp on 08/15/19 at 11:46:24 71785F4E4E474E2B0 wrote:
I don't know how to go about making my own throttle cable. Wish I did. |
Title: Re: Throttle housing, aftermarket? Post by ZSteele on 08/15/19 at 12:21:37 Google and youtube are your friends. Also if you do end up building your own I have a few tips if you don't have all of the proper tools. Hit me up down the line. |
Title: Re: Throttle housing, aftermarket? Post by Tacopimp on 08/15/19 at 12:31:08 71785F4E4E474E2B0 wrote:
Haha. I was already youtubing this when you replied. Doesn't seem too difficult. Thank you for making this suggestion to me. |
Title: Re: Throttle housing, aftermarket? Post by ZSteele on 08/15/19 at 12:59:22 Not at all, just make sure you measure multiple times and check the length with the bars going BOTH directions. Had to do the clutch cable twice because I thought I had them cocked to the longer side. I was wrong. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |