SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Simple Jack fitting
/cgi-bin/YaBB.pl?num=1564185732

Message started by Hiko on 07/26/19 at 17:02:10

Title: Simple Jack fitting
Post by Hiko on 07/26/19 at 17:02:10

This is a very simple fitting to adapt a car scissor jack to suit our bikes
It works very well in conjunction with the side stand and makes a very stable setup for working on either the rear or front wheel
To use I put a block of wood under the side stand foot and put the Jack under the exhaust mounting bracket to lift the rear and the front right footpeg base to lift the front wheel.

I made this fitting from some scrap one inch flatbar in the form of a Y to cradle the bike mounting points and a tongue that extends into the top of the jack.

Title: Re: Simple Jack fitting
Post by SpamyToo on 07/26/19 at 18:15:39

Cool. Nice work. Thanks for the pic.

Title: Re: Simple Jack fitting
Post by DragBikeMike on 07/27/19 at 23:04:53

Thanks for sharing Hiko. That's a neat little rig. Doesn't take up much room in the garage and makes workin on the wheels a whole bunch easier.