|
SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Carb Cleaning Thoughts.... /cgi-bin/YaBB.pl?num=1527727423 Message started by edison on 05/30/18 at 17:43:43 |
|
Title: Carb Cleaning Thoughts.... Post by edison on 05/30/18 at 17:43:43 First off, thanks to all here who assisted me with great advice for cleaning my carb....the bike is now running very well! Without the assurance of technical support here, I doubt I would have tried taking it apart and cleaning it myself. The one issue I had was taking out the float pivot pin - I believe it was bucked in place....I took a Dremel tool to it to take it down but stopped because I didn't want to break the mount after trying to tap it out. Anyway, I have one left over washer that I can't seem to place....it fell off when I moved the seat or tank....does anyone recognize it? ::) |
|
Title: Re: Carb Cleaning Thoughts.... Post by verslagen1 on 05/30/18 at 17:48:18 Oh no! Not that! that's the speedo seal. you'll have to disassemble half the engine to put it back. jk, remove the speedo cable from the case and put it in the bottom of the cable. |
|
Title: Re: Carb Cleaning Thoughts.... Post by edison on 05/30/18 at 17:58:34 Thanks! You had me there for a second.... >:( ;D PS - flat side in first, grooved side toward case...right? |
|
Title: Re: Carb Cleaning Thoughts.... Post by verslagen1 on 05/30/18 at 18:50:42 3E3A325F430B0 wrote:
Yes, grooved side always goes to the pressure side. It energizes the seal. |
|
Title: Re: Carb Cleaning Thoughts.... Post by edison on 05/30/18 at 18:59:46 Thanks again....good principle to know about seal construction! |
|
Title: Re: Carb Cleaning Thoughts.... Post by justin_o_guy2 on 05/30/18 at 20:45:57 554651504F4244464D12230 wrote:
DUDE! That's funny |
|
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |