|
SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Torque Spec sheet /cgi-bin/YaBB.pl?num=1376790269 Message started by Coaxial on 08/17/13 at 18:44:29 |
|
Title: Torque Spec sheet Post by Coaxial on 08/17/13 at 18:44:29 I refer to this one https://docs.google.com/spreadsheet/ccc?key=0Aum3HeLfjZu8dFJKZWJOSUItY043ZVVnZXY4LWFjT1E#gid=0 My question is about how accurate this spec sheet is. I noticed something as I was bolting on my brake calipers. The torque sheet listed above says 4.4-5.9 Ft.Lb while my 86-07 Clymers says 18-28 Ft.Lb |
|
Title: Re: Torque Spec sheet Post by Dave on 08/19/13 at 05:23:56 It appears the torque sheet you listed has switched the values of the large mounting bolts and the pin for the pads. The numbers on the list you posted don't seem to agree very well with what we have posted in the Tech Section in this forum.....so I would not trust that list you linked. Use the Clymers values....or the one in our Tech Section: http://suzukisavage.com/cgi-bin/YaBB.pl?num=1098848534 |
|
Title: Re: Torque Spec sheet Post by Coaxial on 08/19/13 at 12:58:29 Yikes.. that link i have above is in the tech section in that post... |
|
Title: Re: Torque Spec sheet Post by Boofer on 08/19/13 at 17:12:16 Be sure you're not looking at inch pounds. |
|
Title: Re: Torque Spec sheet Post by Coaxial on 08/19/13 at 19:15:12 No the document listed in the Tech section is completely dangerous. I torqued my brake calipers according to this list: 49554741230 wrote:
As posted on http://suzukisavage.com/cgi-bin/YaBB.pl?num=1098848534 My brake caliper bolts ended up loosening. I lost one of them in transit. |
|
Title: Re: Torque Spec sheet Post by Yoshi on 09/07/23 at 18:35:32 All the torque values seem very low on everything listed… I would think the clutch cover bolts could be tightened to 15 ft lbs Driven pulley nut only 65 ft lbs? I don't think so |
|
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |