SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Cap nut issue
/cgi-bin/YaBB.pl?num=1346633217

Message started by tizzyfit on 09/02/12 at 17:46:56

Title: Cap nut issue
Post by tizzyfit on 09/02/12 at 17:46:56

The forward heat shield has two cap nuts.  I was able to remove the most forward of the two with no problem.  The back/lower cap nut has become a bit of an issue.  It turns with a 17mm socket but will not back out.  I've tapped it with a hammer, tried to wedge a screwdriver between the nut and washer, neither of these actions worked.  I've also tried to tighten this nut and it won't engage going that direction either.  I've sprayed it with WD40 in hopes that might do some good but I'm not too optomistic that will accomplish anything.
Any suggestions as to how to get this cap nut off would be appreciated.

Title: Re: Cap nut issue
Post by Serowbot on 09/02/12 at 18:00:19

Da' bolt dat dat nut goes on,.. she goes all the way trough da' motor to da' udder side...
You's got's to have a wrench on dat over dere ,too... else yer' jus spinnin'...
;)...

Title: Re: Cap nut issue
Post by tizzyfit on 09/02/12 at 18:07:50


485E49544C59544F3B0 wrote:
Da' bolt dat dat nut goes on,.. she goes all the way trough da' motor to da' udder side...
You's got's to have a wrench on dat over dere ,too... else yer' jus spinnin'...
;)...

THANKS Serowbot!  I guess, because the forward/upper cap nut bolt didn't extend all the way through the engine, I "assumed" the back bolt was the same, or at least that's my excuse and I'm sticking with it. :-[

Title: Re: Cap nut issue
Post by verslagen1 on 09/02/12 at 18:19:06


38253636352A25384C0 wrote:
[quote author=485E49544C59544F3B0 link=1346633217/0#1 date=1346634019]Da' bolt dat dat nut goes on,.. she goes all the way trough da' motor to da' udder side...
You's got's to have a wrench on dat over dere ,too... else yer' jus spinnin'...
;)...

THANKS Serowbot!  I guess, because the forward/upper cap nut bolt didn't extend all the way through the engine, I "assumed" the back bolt was the same, or at least that's my excuse and I'm sticking with it. :-[/quote]
The forward bolt is like the rear, both have a bolt all the way thru.

You'll need a wrench to tighten it up.

Title: Re: Cap nut issue
Post by tizzyfit on 09/02/12 at 18:32:47

Well, with a 14mm on the kickstand side and a 17mm on the cap nut, withing 30 seconds, I had the cap nut and washer in my hand.  All I can say is my record of turning a 5 minute job into 3 hours is still in tack.
Thanks again Serowbot, now the neighbors won't have to listen to me discuss the sexual preference and family heritage of my Suzuki.

SuzukiSavage.com » Powered by YaBB 2.2!
YaBB © 2000-2007. All Rights Reserved.