SuzukiSavage.com /cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Decomp controller /cgi-bin/YaBB.pl?num=1234193486 Message started by BigSingle on 02/09/09 at 07:31:26

Title: Decomp controller Post by BigSingle on 02/09/09 at 07:31:26 Im working on building my new harness and just ran into something Im not sure about and hopefully can get some clairafication on it.... I noticed that there is a wire that runs from the clutch switch to the decompression controller. What Im tring to figure out is what that wire does and is there a way to bypass the switch..  It looks like it goes Stater switch  -> clutch switch-> decmp controller. So when you pull the clutch in it just connects the wire straight from the starter switch to controller...Looks like I can just connect the two wires together...

Title: Re: Decomp controller Post by savageclay on 02/09/09 at 18:57:59 Yes you can. That's what I did, Just connect the two bypassing the clutch switch.

SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved.