|
SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Valve clearance - what's with Clymer /cgi-bin/YaBB.pl?num=1115671122 Message started by russ_g on 05/09/05 at 13:38:42 |
|
Title: Valve clearance - what's with Clymer Post by russ_g on 05/09/05 at 13:38:42 Clymer doesn't give any measurements for the valve adjustment/tuning. Anyone know what it should be? |
|
Title: Re: Valve clearance - what's with Clymer Post by Reelthing on 05/09/05 at 14:18:44 .003-.005 best I recall |
|
Title: Re: Valve clearance - what's with Clymer Post by Kropatchek on 05/10/05 at 02:59:30 Reelthing wrote:
You'r absolutely right. Suzuki WSM says the same. Better be in the .004 to .005 range. And don't forget to adjust the decompression cable slack at the same time. Greetz Kropatchek ;D |
|
Title: Re: Valve clearance - what's with Clymer Post by Reelthing on 05/10/05 at 05:30:43 also the service manual states to have it cool - that being under 100f |
|
Title: Re: Valve clearance - what's with Clymer Post by russ_g on 05/10/05 at 09:15:21 Thanks all. For curiosity - does the Clymer print this somewhere else in the manual that i've missed. I was just following through the valve procedure in the manual and it didn't give the measurement there - so just wondering if it's in one of their "tables" or something. |
|
Title: Re: Valve clearance - what's with Clymer Post by Reelthing on 05/10/05 at 09:25:02 I think it's in the tune up section |
|
Title: Re: Valve clearance - what's with Clymer Post by Savage_Rob on 05/10/05 at 09:47:47 I know I've seen it but it may have been in the owner's manual. I have to believe it's in the Clymer's somewhere though. Now I'm interested and will need to look it up at home later. |
|
Title: Re: Valve clearance - what's with Clymer Post by Kropatchek on 05/11/05 at 02:05:58 russ_g wrote:
You'r right. Clymer has the "figures" at the back of the chapter in the tables. Greetz Kropatchek ;D |
|
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |