SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Front brakes dragging /cgi-bin/YaBB.pl?num=1096207959 Message started by Pat B on 09/26/04 at 07:12:39 |
Title: Front brakes dragging Post by Pat B on 09/26/04 at 07:12:39 OK, I need some help. My front breaks got worn out in less then 6,000 miles. I replaced the pads, but they are dragging on the front rotor. I have looked through my Clymer manual, but couldn't find anything about dragging pads. Can anyone give me a good starting point?? Thanks in advance |
Title: Re: Front brakes dragging Post by Greg_650 on 09/26/04 at 07:48:04 Does dragging mean that you hear them rubbing like when you are pushing the bike? Are they still new or have you ridden it some? |
Title: Re: Front brakes dragging Post by Pat B on 09/26/04 at 08:10:09 Greg_650 wrote:
Yes, I can hear/feel the dragging. Greg_650 wrote:
I have ridden 400+ miles since the replacement. I read somewhere that you should do 1000 miles before hard stopping, so I have been avoiding that when possible. When I changed the pads, the piston moved freely. I didn't do anything extra to the calipers, and I didn't add any brake fluid. |
Title: Re: Front brakes dragging Post by Greg_650 on 09/26/04 at 08:53:03 Do the brakes work correctly and feel right? Do the brakes squeal when you use them? |
Title: Re: Front brakes dragging Post by Pat B on 09/26/04 at 09:14:45 Greg_650 wrote:
Yes, they work and feel fine. Actualy they feel better then before replacment, now I'm using EBC pads. Greg_650 wrote:
There is no squeal when using them. |
Title: Re: Front brakes dragging Post by Greg_650 on 09/27/04 at 02:47:51 It is quite common to hear a little rubbing sound from the brakes. Just the nature of disc brakes as the float on the sides of the rotor. They do it in a car too. If they don't squeal or feel funny, and still work fine, then I'd say they are okay. You're sure they were installed correctly? |
Title: Re: Front brakes dragging Post by klx650sm2002 on 09/27/04 at 02:52:43 With new brake pads I'd recomend a few hard stops to bed them in and stop them glasing. Clive W :D |
Title: Re: Front brakes dragging Post by Pat B on 09/28/04 at 07:56:01 Greg_650 wrote:
I took them back apart, and they are installed properly, but I still have problems. With the front wheel off the ground, a good hard spin only gets 2-3 revolutions from the wheel. When I take the caliper off it spins 20+ revs with the same spin force. The rotor is true, and I get no change in breaking when stopping. I don't know what else to do. |
Title: Re: Front brakes dragging Post by Greg_650 on 09/29/04 at 02:35:15 That does seem to be a bit tight. It sounds like the pads are not retracting far enough. At this point, I'd suggest bleeding the brake and/or rebuilding the caliper. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |