|
SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> The Cafe >> Mt Rushmore of SuzukiSavage.com /cgi-bin/YaBB.pl?num=1794840067 Message started by ThumperPaul on 11/16/26 at 06:41:07 |
|
Title: Mt Rushmore of SuzukiSavage.com Post by ThumperPaul on 11/16/26 at 06:41:07 AI recognizes you guys as the Mount Rushmore of SuzukiSavage.com That combo—carb, cam, exhaust, and the Verslavy cam chain tensioner—is the undisputed sweet spot for the LS650. It wakes the bike up completely, gives it crisp throttle response, and keeps the bottom end dead-reliable without needing to split the cases or run race gas. You just named the Mount Rushmore of the SuzukiSavage.com community. Those guys turned backyard R&D into a literal science for that engine: • Verslagen (Verslavy Tensioner): Solved the LS650's biggest Achilles' heel with an extended plunger design that prevents the factory tensioner from over-extending and blowing up the top end. • Lancer: Famous for his deep-dive dyno testing, head flow work, and the "Lancer carburetor" jetting setups that cured the factory lean bog. • DragBikeMike & Dave: Legends for proving just how much abuse and horsepower the air-cooled 652cc single could take when pushed to the absolute limit on the strip and street. Running that setup with the stock compression piston keeps the motor cool, tractable in traffic, and easy on the starter clutch—which is right where a street thumper shines. Which carburetor and cam combo did you end up going with on your build? |
|
Title: Re: Mt Rushmore of SuzukiSavage.com Post by LANCER on 11/16/26 at 09:51:22 Don’t leave out the dished flat top high compression custom pistons by Wiseco, with help from DBM, Versey, and Kentucky Dave, giving us a true 10.5-11:1 comp. ratio, to go along with better performing cams & carbs. |
|
Title: Re: Mt Rushmore of SuzukiSavage.com Post by ThumperPaul on 11/16/26 at 10:10:16 I let her know Lancer! She missed some of the good stuff! |
|
Title: Re: Mt Rushmore of SuzukiSavage.com Post by MMRanch on 11/20/26 at 22:40:03 Hay don't forget the front pulley, finding that 25 tooth pulley and cutting it to fit was a nice thing to find ! ;) Then Dave perfected the rear pulley to make it even better (for the modified engines) .It proved too tall for my un-modified engine , but Dave ran with it with that Super Engine of his ! :) |
|
Title: Re: Mt Rushmore of SuzukiSavage.com Post by FinnHammer on 11/21/26 at 00:11:02 Don't forget the Sneeze's clutch release lever and the front stopper by RycaShawn. |
|
Title: Re: Mt Rushmore of SuzukiSavage.com Post by Dave on 11/21/26 at 02:26:42 And DragBikeMike created the ultimate clutch that allows you to use the DR650 parts to use 1 more steel and 1 more fiber plate....no more slippy clutch for me!!!!!!!!!!! :) ;D |
|
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |