SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Strong crank but no start
/cgi-bin/YaBB.pl?num=1793776936

Message started by och on 11/03/26 at 23:22:15

Title: Strong crank but no start
Post by och on 11/03/26 at 23:22:15

Bike sat since around June, when it was running fine, and received a full tank of fresh fuel. Was starting and running just fine.

Went to start it a few weeks ago, cranks strong but no start. Played with the choke, nothing, Drained and recharged the battery a few times, nothing.

Thinking of replacing the spark plug, but what else should I look into?

Title: Re: Strong crank but no start
Post by verslagen1 on 11/04/26 at 05:19:19

sqirt some fuel into the  carb
or drop the bowl and clean the jets

Title: Re: Strong crank but no start
Post by splash07 on 11/04/26 at 07:48:18

Fuel, Spark, air/compression. Start with fuel, like versy said spray some starting fluid or fuel into the intake and see if it fires over. If not then check for spark. Likely one of those two issues. I would also suggest load testing the battery just to be sure.

Title: Re: Strong crank but no start
Post by Axman88 on 11/04/26 at 08:21:50

With 10% ethanol fuel being the only stuff I can buy here in Chicago, I don't expect fuel older than 10 weeks to be of much use.  The most volatile fraction evaporates and what is left absorbs humidity during storage.  I drain it out of moto tanks, and mix it with fresh gas into some vehicle with EFI and many cylinders.

If the bike still has its factory vacuum activated petcock, I'd want to make sure it was in its bypass position.  If the vacuum line has fallen off, or even cracked, that petcock valve will no longer open, not with the engine running, and definitely not while cranking.  The internal diaphragm's on these can also get stiff over time, or crack.  Definitely high on my list of suspect items on any machine which equipped with a vacuum activated petcock.

SuzukiSavage.com » Powered by YaBB 2.2!
YaBB © 2000-2007. All Rights Reserved.