SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> 2008 -- repairing a cracked turn signal
/cgi-bin/YaBB.pl?num=1773079879

Message started by ak.pdx on 03/09/26 at 11:11:18

Title: 2008 -- repairing a cracked turn signal
Post by ak.pdx on 03/09/26 at 11:11:18

Hello All,

Anyone successfully repaired/glued back together a broken turn signal housing?
I've tried to use the 'Barge Cement,' but it turned out like using a chewing gum. :-(
Would SuperGlue work? Or possibly JB-Weld?

Prices for a new one seem a bit excessive ($95-140), and I haven't seen any used one. It's the Front Right, BTW

Thanks

Title: Re: 2008 -- repairing a cracked turn signal
Post by zevenenergie on 03/10/26 at 01:54:02

I use JBweld for almost everything, but I've found that plastics are difficult to glue, and often impossible. I personally think superglue gives the best results here. If it's glued in place properly, I'd see if I can add some reinforcement.