SuzukiSavage.com /cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Clutch replacement problem /cgi-bin/YaBB.pl?num=1741402397 Message started by Suzuki86prince on 03/07/25 at 18:53:17

Title: Clutch replacement problem Post by Suzuki86prince on 03/07/25 at 18:53:17 Hey everyone, I recently change all my clutch plates friction and steel. I bought them from fortnine, I purchased 1-Barnett Clutch Friction Plate Kevlar, 5 Barnett Clutch Friction Plate Kevlar, 5 Barnett Steel Clutch Drive Plate 1.6mm thick, and the Barnett Clutch Spring Kit. After putting all this back in the bike I have a lot of slack in the clutch. Like I have both set nuts loosed all the way out?  Can any body give me any help. I know there are different clutch pins but would that change after putting different plates in?

Title: Re: Clutch replacement problem Post by Surviving Philly on 03/10/25 at 14:48:52 Assuming the cable is correctly tensioned at the perch (handlebar) and the case, I think you probably screwed up the clutch re-assembly, just my two cents. https://www.youtube.com/watch?v=vJE6G0MjYbI&ab_channel=MiguelQuartermile Check out these videos from dragbikemike he runs through the entire job

SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved.