SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Need help - removed stator cover, gear fell out
/cgi-bin/YaBB.pl?num=1662071707

Message started by och on 09/01/22 at 15:35:07

Title: Need help - removed stator cover, gear fell out
Post by och on 09/01/22 at 15:35:07

Guys, I need help ASAP, I removed the stator cover and a gear fell out, now I'm not sure which way it faces as its flat on one side and has protrusion on the other side. I think its the starter gear. I also understand there should be 2 washers, I only found one, I think it fell out with the gear, is it going behind the gear or on top of the gear between the stator cover?

Also, what are the torque specs for the stator cover?

Title: Re: Need help - removed stator cover, gear fell ou
Post by verslagen1 on 09/01/22 at 17:25:01

the washers go on the torque limiter gear only (1 on either side), not the idler gear next to the starter.

Take a look at the gear when you get it installed, does it line up with the TLG?

the washer might be stuck to the case with oil, or on the rotor... dam magnets.

we post these lists in the tech section for a reason.

Title: Re: Need help - removed stator cover, gear fell ou
Post by och on 09/01/22 at 17:36:30

7E6D7A7B64696F6D6639080 wrote:

Yep, I figured that part out, I was confused by other posts. The idler gear fell out, I though the washer goes on the idler gear. I put the washer on the torque limiter gear.