SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> White spacer mod question /cgi-bin/YaBB.pl?num=1642818148 Message started by JED on 01/21/22 at 18:22:28 |
Title: White spacer mod question Post by JED on 01/21/22 at 18:22:28 Doing the white spacer mod. It appears there’s an e-clip with about 7 positions. What position should the clip be? Also couldn’t I just put the clip in a lower position and then there’s no need to remove the white spacer? Or, maybe I don’t have OEM parts. |
Title: Re: White spacer mod question Post by Gary_in_NJ on 01/21/22 at 19:20:10 Either you don’t have the correct needle for the carb, or you don’t have an OEM CV carb. |
Title: Re: White spacer mod question Post by JED on 01/21/22 at 22:07:37 Thanks. It’s a Mikuni CV but the previous owner must’ve installed this different jet needle. Does the proper needle only have one groove for the e-clip like in this photo? |
Title: Re: White spacer mod question Post by zipidachimp on 01/21/22 at 22:44:48 Yes! I used a tiny dab of superglue on my finger and ran the spacer back and forth across a piece of sandpaper to 1/2 thickness. Use a caliper to measure it. Backfires(afterfires) much reduced. Cheers! 8-) |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |