SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Cone filter&battery box top cover issue /cgi-bin/YaBB.pl?num=1629425797 Message started by TRLREDY on 08/19/21 at 19:16:37 |
Title: Cone filter&battery box top cover issue Post by TRLREDY on 08/19/21 at 19:16:37 I recently acquired an '03. A previous owner removed the air box and put a cone filter on the carb. The also put a larger batter in it and hacked the batter box to fit said battery. It now has the correct size battery and I bought a used box for it. Thought all would be good. Now I see that the top cover won't fit because it hits the cone filter. Is there another filter out there that will allow the top cover to be on? Could I just get a stock intake tube and put it on the carb and cone filter on the other end so the filter would essentially be where the air box once was? I like the looks of the filter on the carb but its not a must have for me. I'm open to any solutions you all may have. Thank you! |
Title: Re: Cone filter&battery box top cover issue Post by zipidachimp on 08/19/21 at 22:53:56 What model cone? I'm using KN RG1250, plenty of room. I did trim my battery box so it's only 3 sides and a bottom, held in place by a side cover. Cheers! 8-) |
Title: Re: Cone filter&battery box top cover issue Post by TRLREDY on 08/20/21 at 04:59:24 Thanks zipidachimp. I'll see if if can find a #. I'm guessing its just a generic. I'll probably go ahead and swap it out regardless and see where that gets me. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |