SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Raptor Petcock Install Question /cgi-bin/YaBB.pl?num=1629425047 Message started by TRLREDY on 08/19/21 at 19:04:07 |
Title: Raptor Petcock Install Question Post by TRLREDY on 08/19/21 at 19:04:07 Hey all! I've read through the various posts regarding this topic but I haven't seen my specific question addressed so here goes. I did the install last night. All went well till it was time to put the Raptor in. The brass tube has the white plastic/mesh extension on it. Over top that mesh was clear plastic tubing. Like aerator tubing for a fish tank or something. That plastic sleeve made it too thick to fit up into the tank. As i tried to insert it that clear sleeve started sliding down. So I removed the clear tubing and the petcock went into the tank no problem. Is that tubing just there for protection for shipping/storage etc? Did I do the right thing by removing it? Thank you and sorry for the long narrative! |
Title: Re: Raptor Petcock Install Question Post by verslagen1 on 08/19/21 at 22:39:51 just there for protecting during shipping, remove before flight. |
Title: Re: Raptor Petcock Install Question Post by TRLREDY on 08/20/21 at 04:55:57 Thank you verslagen1. I really appreciate the info! Been stressing about it. Brand new to all of this. Just recently acquired my '03 and have a lot to learn. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |