SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> 1986 savage decompression
/cgi-bin/YaBB.pl?num=1623979278

Message started by Crowman on 06/17/21 at 18:21:18

Title: 1986 savage decompression
Post by Crowman on 06/17/21 at 18:21:18

Hello hope someone can assist.me, Iam new to this. I.have a 1986 savage, bought few years ago. I have completed most of it and some parts are missing. Can anyone tell me where the decompression actuator release is located. I have it not sure where it fits, I hope someone can direct me to a picture where it goes. Also I don't have a decompression relay control unit nor a decompression solenoid, do I need those to get the bike up and running ? just want a bare bones wiring with signal lights. I have all other parts that I can tel. Any help would be greatly appreciated. Thank you so much for any help. :'(

Title: Re: 1986 savage decompression
Post by Dave on 06/17/21 at 19:05:54

See if what you want is in this thread.

http://suzukisavage.com/cgi-bin/YaBB.pl?num=1327512118/9

I believe RYCA also had some YouTube videos posted on how to reroute the wires to eliminate the side stand switch and decompression controller.

Title: Re: 1986 savage decompression
Post by verslagen1 on 06/17/21 at 19:35:26

something else to think about...
http://suzukisavage.com/cgi-bin/YaBB.pl?num=1288911670

and here's a lot of pictures...
http://suzukisavage.com/cgi-bin/YaBB.pl?num=1199986392

Title: Re: 1986 savage decompression
Post by ohiomoto on 06/18/21 at 17:52:28

Is the triplicate thread? Seems like I've seen a poll or two on this topic. :o