SuzukiSavage.com /cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Intruder Shock Mounting /cgi-bin/YaBB.pl?num=1608530844 Message started by Mavigogun on 12/20/20 at 22:07:24

Title: Intruder Shock Mounting Post by Mavigogun on 12/20/20 at 22:07:24 Will the stock bolts suffice, or will longer be required? I notice the shock features a recessed bolt hole unlike the stock shock- will the stock washer fit in there, or must a smaller part be resourced? Thanks for any insight.

Title: Re: Intruder Shock Mounting Post by Serowbot on 12/21/20 at 07:37:28 Stock bolts and nuts are fine,... washers?  I can't remember. Do pay attention to clearances around the front pulley. Especially if you still have the stock belt guard.  Some trimming may be necessary. If you have the stock muffler, and rear footpegs there may be an issue as well. Good time for a Shorty Sporty... Good luck.  8-)

SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved.