SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> side stand electric circuit /cgi-bin/YaBB.pl?num=1606335564 Message started by Rich McLuvvin on 11/25/20 at 12:19:24 |
Title: side stand electric circuit Post by Rich McLuvvin on 11/25/20 at 12:19:24 Hi. I want to bypass the side stand electric circuit. can I just disconnect the sidestand switch, sidestand relay and sidestand diode? |
Title: Re: side stand electric circuit Post by Gary_in_NJ on 11/25/20 at 13:21:25 It's been a few years...but if my memory is correct you have to complete the circuit. This makes the ECU "think" that the side stand is in the up condition. |
Title: Re: side stand electric circuit Post by Dave on 11/25/20 at 16:41:35 Yep.....just unplug the connector that is located on the frame downtube just above the pulley, and run a jumper wire between the terminals. |
Title: Re: side stand electric circuit Post by Rich McLuvvin on 11/27/20 at 11:41:45 Has anyone else bypassed their silly sidestand circuit? :o |
Title: Re: side stand electric circuit Post by Rich McLuvvin on 11/27/20 at 11:44:16 thanks Gary and Dave. I'll do that. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |