SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Electrical connections /cgi-bin/YaBB.pl?num=1591527858 Message started by martin jarvis on 06/07/20 at 04:04:18 |
Title: Electrical connections Post by martin jarvis on 06/07/20 at 04:04:18 Does anyone know what these two are for? |
Title: Re: Electrical connections Post by Gary_in_NJ on 06/07/20 at 04:22:32 The green one is for the side stand interlock signal to the ECU. |
Title: Re: Electrical connections Post by martin jarvis on 06/07/20 at 08:47:03 32383C363D343039676165550 wrote:
Thanks, won't be needing that so will cut it out of the loom |
Title: Re: Electrical connections Post by Gary_in_NJ on 06/07/20 at 11:49:15 You’ll have to complete the circuit. The ECU will see an open circuit as the side stand being down and the ECU will cut spark when you put it into gear. |
Title: Re: Electrical connections Post by martin jarvis on 06/08/20 at 13:08:34 3E34303A31383C356B6D69590 wrote:
Yes but I don't need the plug. I have also removed the decompressor. Starts fine without it. it's all just extra weight and extra junk to hide where there is not a lot of hiding place on my bike. I can't work out what the other plug is for though |
Title: Re: Electrical connections Post by SavageMan99 on 06/09/20 at 07:44:29 Nuetral? |
Title: Re: Electrical connections Post by Dave on 06/10/20 at 03:13:23 The neutral wire runs up the right side of the frame and is a single wire. the connector is on the backbone just above the cylinder head. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |