SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Ignition Coil connection
/cgi-bin/YaBB.pl?num=1584028706

Message started by John E Black on 03/12/20 at 08:58:26

Title: Ignition Coil connection
Post by John E Black on 03/12/20 at 08:58:26

Howdy all.
Getting ready to replace the ignition coil. The spark plug cap needs to be attached to the coil and it looks like the cap screws onto the lead wire.

Is this correct? Looks pretty cut and dried but wondering if there are any tips to making sure this connection is correct.

Thx in advance!
jb

Title: Re: Ignition Coil connection
Post by Gary_in_NJ on 03/12/20 at 10:37:27

You've got the concept. Screw the new cap onto the lead.

Title: Re: Ignition Coil connection
Post by John E Black on 03/12/20 at 12:10:24

Thanks much...what sometimes looks like a no brainer, is actually not.

BTW, just checked out the link to your bike; sweet build. If I may ask, what are the specs for the rears shocks?

Again, great bike.

Title: Re: Ignition Coil connection
Post by Gary_in_NJ on 03/12/20 at 13:51:27

Thanks! Fun bike to ride and own.

They are reworked/rebuilt RFY Pippyback shocks. They were setup by CL MotoTech. I think they have dual rate springs in the 100-130 range. They are adjustable between 13.0 and 13.5 inches. I have them set at 13.25...any longer and i get chain slap on the swingarm.

Title: Re: Ignition Coil connection
Post by John E Black on 03/15/20 at 10:55:58

Many thanks for the info on the shocks..will def check them out.