SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Swingarm Silliness /cgi-bin/YaBB.pl?num=1568549519 Message started by Armen on 09/15/19 at 05:11:58 |
Title: Swingarm Silliness Post by Armen on 09/15/19 at 05:11:58 So, I've been playing with a very cool aluminum alloy called 7068. Rated as as strong as 404 Stainless (although it prob flexes a tiny bit more). Decided to make a swingarm pivot pin out of the stuff. Figured that loaded in shear, it really can't go too far wrong (and really can't flex). Made a pin and a nut. Figure that they are so cute (and can't rust), that I can leave the caps off the ends. Goal is to knock 100 pounds off the bike. This is about 1/2 pound. It all adds up :-0 BTW, I never use the torque spec for a swingarm pin. I pull the shocks and slowly tighten the swingarm pivot nut until the swingarm just falls under it's own weight. No slop, no binding, no drag. They seem happiest this way. |
Title: Re: Swingarm Silliness Post by Armen on 09/15/19 at 05:12:44 And now in aluminum... |
Title: Re: Swingarm Silliness Post by ZSteele on 09/15/19 at 05:17:38 Are you planning on selling all of these light weight replacements down the road Armen? Especially as a set. |
Title: Re: Swingarm Silliness Post by Armen on 09/15/19 at 05:27:32 Nope, not for sale. Not cost effective for me to make them. Just posting it as puttering porn. |
Title: Re: Swingarm Silliness Post by ZSteele on 09/15/19 at 05:51:13 Drat, was lookong forward to the idea of a 200lb cafe racer! |
Title: Re: Swingarm Silliness Post by Dave on 09/15/19 at 06:25:29 646D4A5B5B525B3E0 wrote:
Then you should start with something smaller than the Savage......the engine weighs close to 100 pounds! |
Title: Re: Swingarm Silliness Post by ZSteele on 09/15/19 at 07:26:09 But the thumpy is so much funnnn [ch128521] |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |