SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> The Cafe >> I need a sissy bar
/cgi-bin/YaBB.pl?num=1557513179

Message started by justin_o_guy2 on 05/10/19 at 11:32:59

Title: I need a sissy bar
Post by justin_o_guy2 on 05/10/19 at 11:32:59

Or some 5/8" square stock.
I've answered posts in the marketplace and started a thread, I'm just dropping this here hoping someone who doesn't frequent the marketplace can help me out.

Title: Re: I need a sissy bar
Post by Dave on 05/11/19 at 04:23:32

Are you turning into a sissy? :-?

Are you looking for a factory sissy bar....or looking to make one?

You could go to Online Metals and get some 5/8" stock in stainless.....and do some heating and bending and polishing.

Title: Re: I need a sissy bar
Post by justin_o_guy2 on 05/11/19 at 10:26:41

I'm wanting raw steel.
It's gonna get welded to.
I'm building a rack for the milk crate with a upright and a shelf over the tail light.
I've got the square tubing, but I don't want to wreck my sissy bar. I need about two or three feet of 5/8" square stock, that should be enough to cover the losses of the learning curve while I try to get it right. I really don't want to buy 24',, which is what I had to get for the tubing.

Title: Re: I need a sissy bar
Post by verslagen1 on 05/11/19 at 10:35:58

why not just use the tubing and bend your own?

Title: Re: I need a sissy bar
Post by justin_o_guy2 on 05/11/19 at 12:14:42

It's not 5/8". And it's not solid. The bike shakes. Hard.