SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Correct position of plate?
/cgi-bin/YaBB.pl?num=1541187018

Message started by Drifter.. on 11/02/18 at 12:30:18

Title: Correct position of plate?
Post by Drifter.. on 11/02/18 at 12:30:18

What is the correct position of the plate that holds the needle in place in the slide? Both holes open or both partially blocked or one blocked? Some one was in this carb before me so i do not know what is right and the hayes manual has a blurry pic so i cant see the correct position. Thanks in advance!

Title: Re: Correct position of plate?
Post by justin_o_guy2 on 11/02/18 at 12:56:45

The plate is correctly located when it's equidistant between my fork and my knife.

Title: Re: Correct position of plate?
Post by verslagen1 on 11/02/18 at 12:59:45

Both holes (in the slide) open.
Align the slots (in the plate) with the holes.

Title: Re: Correct position of plate?
Post by Drifter.. on 11/02/18 at 15:04:11

Thanks, that is where i put it both holes open!

There is always one.....guy in every crowd! ;)

Title: Re: Correct position of plate?
Post by justin_o_guy2 on 11/02/18 at 15:40:12

EVEN if the
Crowd is two.

Title: Re: Correct position of plate?
Post by batman on 11/02/18 at 21:26:39

There is a small dimple in the plate close to the jet needle .it must protrude downward or the plate is upside down.