SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Carburetor top cap removal /cgi-bin/YaBB.pl?num=1524242720 Message started by Jurzum on 04/20/18 at 09:45:20 |
Title: Carburetor top cap removal Post by Jurzum on 04/20/18 at 09:45:20 How do open top cap bolts? My screws are so tight that there is no way to open without breaking them... I really want to adjust the needle height. |
Title: Re: Carburetor top cap removal Post by verslagen1 on 04/20/18 at 09:53:13 They use locktite on everything. If you support the bottom of the flange, you can use a small impact driver. But, you can just grab the head with a vice grip and wrench it off. |
Title: Re: Carburetor top cap removal Post by norm92de on 04/20/18 at 11:55:02 After you do that replace the screws with Allen head screws. All of them on the carb. No more headaches. :) |
Title: Re: Carburetor top cap removal Post by Jurzum on 04/21/18 at 22:09:16 Thanks guys! Job well done :) |
Title: Re: Carburetor top cap removal Post by batman on 04/22/18 at 11:35:39 Replacement Allen head screws: top cover, M5x 10mm (4 needed) throttle(left side) bracket, M5x10mm (2) Float bowl, M5x16mm (4) TEV valve (right side) cover, M4x10mm (3) |
Title: Re: Carburetor top cap removal Post by norm92de on 04/22/18 at 12:46:48 Very helpful answer batman. That will help him track down the screws. They sure make it easier to work on the carb. :) |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |