SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Cone filter /cgi-bin/YaBB.pl?num=1518526870 Message started by Beggaa on 02/13/18 at 05:01:10 |
Title: Cone filter Post by Beggaa on 02/13/18 at 05:01:10 Has anyone used a cone filter on thier Savage? With a stock muffler, what would the jetting be at sea level. What did you do with the breather tube? |
Title: Re: Cone filter Post by batman on 02/13/18 at 06:47:10 When you first come to the site look to the right of the page ,the tech section has a lot of info ,look under fuel & exhaust. |
Title: Re: Cone filter Post by Beggaa on 02/13/18 at 07:55:41 Thanks, didn't see that earlier |
Title: Re: Cone filter Post by batman on 02/13/18 at 23:19:26 If you decide to use the cone filter you should use all or part of the hose that ran between the carb and stock air box ,this will avoid two possible problems . the rubber base of the cone filter blocking air passages in the mouth of the carb( which could hamper the slide movement) ,and it will allow the air to straighten before it enters the carb which helps with hp. |
Title: Re: Cone filter Post by Yoshi on 02/14/18 at 03:12:30 55 pilot 152.5 main If you want to mount the filter right on the carb use k&n pn RC-1250 |
Title: Re: Cone filter Post by batman on 02/15/18 at 10:01:57 Yoshi ,what did you use for the spacer mod, with the 55/152.5 setup? |
Title: Re: Cone filter Post by Yoshi on 02/15/18 at 13:27:06 2 washers |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |