SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Re: Carburetor Specifications /cgi-bin/YaBB.pl?num=1508451845 Message started by Pdk50 on 10/19/17 at 15:24:04 |
Title: Re: Carburetor Specifications Post by Pdk50 on 10/19/17 at 15:24:04 Not sure if I'm posting in the right area, but can a carb. from a 2002 be used on a 2013 S40? |
Title: Re: Carburetor Specifications Post by verslagen1 on 10/19/17 at 15:57:28 70646B3530000 wrote:
Fixed that for you. Quote:
All the interfaces are the same. There might be some jets that are different, but functionally the same. Don't interchange any of the jets with any other model and you should be fine. |
Title: Re: Carburetor Specifications Post by Kris01 on 10/19/17 at 18:58:58 You'd need to verify the jet sizes. Some carbs were factory built a certain way depending on the location. California carbs are jetted leaner than any other state. Certain years were also jetted differently. The jets are all interchangeable. You can use your jets in the "new" carb. |
Title: Re: Carburetor Specifications Post by Dave on 10/20/17 at 03:53:19 546D766C2F2E1F0 wrote:
You should only change the Main and Pilot jets if needed.....don't be mixing any other jets, slides, emulsion tubes, etc. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |