SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Cylinder head intake manifold bolt spacing /cgi-bin/YaBB.pl?num=1504095429 Message started by kojones on 08/30/17 at 05:17:09 |
Title: Cylinder head intake manifold bolt spacing Post by kojones on 08/30/17 at 05:17:09 Difficult to measure accurately with the carb in there, how much is it? Thanks :) |
Title: Re: Cylinder head intake manifold bolt spacing Post by Kris01 on 08/30/17 at 17:00:13 I have no answer for you. Sorry! But I am curious. What are you trying to do? Just remove the carb. [WOW! That was easy to type! Removing the carb is easy. Putting it back in is a different story! LOL!!!] |
Title: Re: Cylinder head intake manifold bolt spacing Post by kojones on 08/30/17 at 23:49:51 6A5348521110210 wrote:
Yeah, it's only a two hour job to remove the carb and putting it back in ;D Will do that when the driving season is over, but there's no ice and snow outside yet. I'm replacing the carburetor with a VM36 and need to get a new intake rubber as well. It's 70 or 75 mm, that much I could say. |
Title: Re: Cylinder head intake manifold bolt spacing Post by Kris01 on 08/31/17 at 18:00:07 2 hours!?!?!? That would be record time for me! |
Title: Re: Cylinder head intake manifold bolt spacing Post by Fast 650 on 09/04/17 at 10:21:47 I have the head off mine right now, so it is easy to measure. I get 70mm center to center on the screws. |
Title: Re: Cylinder head intake manifold bolt spacing Post by kojones on 09/04/17 at 10:33:18 4B6C7E793B383D0D0 wrote:
Thank you very much! Now I just have to wait to get the carb, testing will have to wait for next summer. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |