SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> My POD Filter Setup /cgi-bin/YaBB.pl?num=1499644590 Message started by antmanbee on 07/09/17 at 16:56:27 |
Title: My POD Filter Setup Post by antmanbee on 07/09/17 at 16:56:27 This is how I setup my intake filter after removal of the airbox. I always if possible like to retain the intake track tube to assure a smooth flow of air into the carb or throttle body. In this case I just got a 2" PVC elbow and cut off the big ends and shortened it quite a bit and angled it down so the filter would sit a little lower. I could have probably used a short straight piece of PVC also which would have made the top of the filter touch the stock seat pan. I used a UNI UP 4245 POD FILTER that cost me about $14. |
Title: Re: My POD Filter Setup Post by Ruttly on 07/09/17 at 17:46:30 Nice job ! |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |