SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Winter Bobber Project
/cgi-bin/YaBB.pl?num=1492277716

Message started by Jarry63 on 04/15/17 at 10:35:06

Title: Winter Bobber Project
Post by Jarry63 on 04/15/17 at 10:35:06

I started this last fall while I was away from home.  Since I got back I've been working slowly, but it's coming around.  I know there was a few people asking how I was going to mount the spring seat without modifying the frame.  Here's a few pic's and how I did it.  Basically, I bent the factory seat mounts and bolted a 2" spring to the mount then the seat, after that I mounted the front using longer bolts to the rear gas tank mount.  It doesn't have a lot of spring, but it works.  I'm still working on it, but it's slowly coming around.

Title: Re: Winter Bobber Project
Post by Jarry63 on 04/15/17 at 10:37:30

Here's a right side view.

Title: Re: Winter Bobber Project
Post by Jarry63 on 04/15/17 at 10:44:25

Seat up close, I still need to fabricate something to cover up the wiring, but again it's a slow project.

Title: Re: Winter Bobber Project
Post by Dagillespi on 04/17/17 at 19:52:59

That's how I set my sest up too it's working well so far. Like the bike looks good.

SuzukiSavage.com » Powered by YaBB 2.2!
YaBB © 2000-2007. All Rights Reserved.