SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Cable tracing - Clutch and throttle
/cgi-bin/YaBB.pl?num=1491995722

Message started by Mekh on 04/12/17 at 04:15:22

Title: Cable tracing - Clutch and throttle
Post by Mekh on 04/12/17 at 04:15:22

Hi,

Do any of you have some photos or sketches that shows how you have your cables going from the handlebar to wherever they are supposed to go?

PS.
Do you call it "cable tracing" or how would you call it? (For future reference)

Title: Re: Cable tracing - Clutch and throttle
Post by norm92de on 04/12/17 at 06:26:23

Mekh,
I think there is a diagram of the cable routing in the Suzuki workshop manual.

On my bikes I usually route my own cables. Just make sure that they run fair.

Title: Re: Cable tracing - Clutch and throttle
Post by LANCER on 04/12/17 at 07:20:47

http://https://s26.postimg.org/xh9b3tq1l/Savage_cable_diagram.jpg

Title: Re: Cable tracing - Clutch and throttle
Post by Mekh on 04/12/17 at 07:28:22

Is that from Clymers, and if so what chapter?

I can't seem to find it there...

Title: Re: Cable tracing - Clutch and throttle
Post by Mekh on 04/12/17 at 08:23:10

Never mind... Now I can see what is on the picture... At first it was really small :)

Thanks a lot, that is very helpful.

Title: Re: Cable tracing - Clutch and throttle
Post by TheNaughtyLemur on 05/16/17 at 10:08:55

I pulled the carb to rejet and inadvertently messed with the routing of the throttle cable, where if you push the handlebars all the way to the left it slightly revs the engine.

This will be very helpful, thank you.