SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> The Cafe >> Gas tank petcock swap My version! /cgi-bin/YaBB.pl?num=1490927155 Message started by GIXXER on 03/30/17 at 19:25:26 |
Title: Gas tank petcock swap My version! Post by GIXXER on 03/30/17 at 19:25:26 What does everyone think of my style of a petcock swap? Im ready for the the highs and lows of this conversation lol! |
Title: Re: Gas tank petcock swap My version! Post by GIXXER on 03/30/17 at 19:31:57 Definitely not the 660 raptor swap. |
Title: Re: Gas tank petcock swap My version! Post by verslagen1 on 03/30/17 at 19:37:23 Hey your knob is hanging out. :-? |
Title: Re: Gas tank petcock swap My version! Post by GIXXER on 03/30/17 at 19:51:13 Lol! Gotta get people's attention somehow. There's always other options out there especially if your a machinists. ;D |
Title: Re: Gas tank petcock swap My version! Post by piedmontbuckeye on 03/31/17 at 06:15:23 I did the Raptor swap - much better than original. However, I still hate the "lever" as I can't move it with gloves on and I ride a lot in colder weather. I am thinking of mfg. my own lever, but not like the one pictured above!! I just don't like my "knobs" hanging out there like that! |
Title: Re: Gas tank petcock swap My version! Post by bobert_FSO on 03/31/17 at 08:53:01 I like it. Good job. |
Title: Re: Gas tank petcock swap My version! Post by Gary_in_NJ on 03/31/17 at 11:02:17 What's it off of? What are the section lengths of the primary and reserve? |
Title: Re: Gas tank petcock swap My version! Post by Kris01 on 03/31/17 at 18:11:59 Modified Raptor? |
Title: Re: Gas tank petcock swap My version! Post by GIXXER on 03/31/17 at 19:07:31 Ok everyone the fuel petcock is Yamaha. It is any petcock that crossreferences with the o'ring seal that goes to the 660 raptor. "Partzilla" I happened to have it laying around from my Tri-FZ450 project. I wasn't going to buy a new one for a 660 that cost $23.00. And I don't like how they look. So as anyone would know that has a 06 yfz450 , the knob on them sticks WAYY OUT.!.! so I took the plastic knob off and made a new one that's 304 stainless steel. It's about 2 hours of work that I like a lot more than the stock one. It doesn't stick out but .400 . Not anymore than a raptor knob would. This one is pretty easy to turn with riding gloves on. Have plenty of info on this if anyone else wants to do this swap. |
Title: Re: Gas tank petcock swap My version! Post by GreasyJonny on 05/16/17 at 10:52:58 646A7B7B6671230 wrote:
I have a raptor incoming but I'd be into doing something like this. Also a machinist. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |