SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Float bowl gasket query /cgi-bin/YaBB.pl?num=1487158991 Message started by eau de sauvage on 02/15/17 at 03:43:11 |
Title: Float bowl gasket query Post by eau de sauvage on 02/15/17 at 03:43:11 Hi y'all. Gonna do some more carb work tomorrow and I bought a new float bowl gasket. The old one seemed OK last time I had it out but I thought it best to have a spare on hand. Anyhoo, I was just wondering if I do use a new gasket does it require any prepping, or just put it on dry. |
Title: Re: Float bowl gasket query Post by Ruttly on 02/15/17 at 03:51:10 Dry , no glue required ! |
Title: Re: Float bowl gasket query Post by eau de sauvage on 02/15/17 at 04:04:35 Okie dokie thanks. Dry it is. btw I was thinking a bit of oil rather than glue, but I'll go dry. |
Title: Re: Float bowl gasket query Post by Dave on 02/15/17 at 04:12:58 No oil......if you were going to put anything on it, I would use silicone grease.....just enough to make the surface slick. However.....the float bowl gaskets seem to hold up just fine without anything being applied. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |