SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> idle mix screw
/cgi-bin/YaBB.pl?num=1476719040

Message started by hammerman47 on 10/17/16 at 08:44:00

Title: idle mix screw
Post by hammerman47 on 10/17/16 at 08:44:00

Baught a used 2003 650 and am tring to get it set up. Adjusted idle mix screw and found no change. Pulled screw and found spring and no rubber washer at end. Can I get one locally or where do I find one? Thanks James

ajuusting

Title: Re: idle mix screw
Post by Gary_in_NJ on 10/17/16 at 09:03:07

ronayers.com

Title: Re: idle mix screw
Post by stewmills on 10/17/16 at 09:40:55

If you have a local ACE hardware, it's worth a shot checking there. Not guaranteed they will have one that small, but I have been impressed with how much my local ACE has.

Also, make sure you look down in the hole and don't see the rubber washer in there. It doesn't always come out just by pulling the screw...it's in there sorta snug.

Title: Re: idle mix screw
Post by hammerman47 on 10/17/16 at 13:47:27

Thanks all. Tried ace no luck. Calling ron ayers.

Title: Re: idle mix screw
Post by justin_o_guy2 on 10/17/16 at 16:25:44

I thought it just landed in a tapered seat, I didn't know a rubber Anything was involved.

Also, dropping idle RPM allows you to pick out the effects of the adjustments.

Title: Re: idle mix screw
Post by Kris01 on 10/17/16 at 19:35:05

233C3A3D20271626162E3C307B490 wrote:

I thought it just landed in a tapered seat, I didn't know a rubber Anything was involved.

I thought the same thing.

What do you mean by you "pulled the screw"? Drop the idle and adjust the screw 1/8 turn or so until you find the highest idle speed. Then turn your idle back to the correct 1100 rpms.

Title: Re: idle mix screw
Post by stewmills on 10/17/16 at 20:16:34

Ok...let's post this picture again. Ta-da! Rubber washer!

Title: Re: idle mix screw
Post by Kenny G on 10/17/16 at 20:40:41

Stew,

Thank You!

A wise man once said: "A picture is worth a thousand words."

Kenny G

Title: Re: idle mix screw
Post by justin_o_guy2 on 10/17/16 at 20:53:55

Yeah, but his brother in law was a photographer and his biggest enemy was an author, so,