SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Carburetor needle valve spacers /cgi-bin/YaBB.pl?num=1475548299 Message started by HefyJefy on 10/03/16 at 19:31:39 |
Title: Carburetor needle valve spacers Post by HefyJefy on 10/03/16 at 19:31:39 So I finally got around to tweaking the needle spacer on the 2015 s40 Boulvard. This is to try and smooth out the surging at mid-throttle settings that this bike has had from day one. My question is whether there are different spacers available and if so how do the thicknesses change? I made a replacement nylon spacer that was about half the thickness of the stock one and it seems to have improved things. (The original was 3mm) Geoff |
Title: Re: Carburetor needle valve spacers Post by Dave on 10/04/16 at 03:00:27 Most of us just go to a good hardware store, and buy washers made for #4 machine screws. Most bikes respond well to replacing the white spacer with 3 washers. My bike still had a mid throttle surge - and removing 1 more washer and running just 2 on the needle cured it. |
Title: Re: Carburetor needle valve spacers Post by HefyJefy on 10/04/16 at 06:50:27 OK thanks. Yes I wondered whether the material being nylon was important - seems not. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |