SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Exaust Bolts
/cgi-bin/YaBB.pl?num=1475465141

Message started by mkelee on 10/02/16 at 20:25:40

Title: Exaust Bolts
Post by mkelee on 10/02/16 at 20:25:40

I am missing the exhaust bolts or studs.
Can anyone tell me the length and size and Thread pitch please?
Thank You!

Title: Re: Exaust Bolts
Post by Kenny G on 10/02/16 at 21:10:26

Lee,

http://www.ronayers.com/oemparts/a/suz/54cbade787a865124878430f/cylinder-head

It is Item #47. I don't know the bolt size or thread pitch.

When you find out what size you need you may want to consider using studs and lock washers and nuts along with plenty of anti-seize.

Be careful tightening, regardless of what fastener you decide on. Use 1/4" drive tools and a light twist.

Kenny G

Title: Re: Exaust Bolts
Post by Kris01 on 10/02/16 at 21:30:30

When you find out, post the info here:
http://suzukisavage.com/cgi-bin/YaBB.pl?num=1166804153

Title: Re: Exaust Bolts
Post by verslagen1 on 10/02/16 at 22:29:33

8 dia
1.25 pitch
35 long

Title: Re: Exaust Bolts
Post by Dave on 10/03/16 at 03:04:32

Don't just use any "cheap" hardware store bolt in there. The factory pieces are good quality chrome bolts. If you use something cheap that can corrode.....they are a real beaitch to get out if they break off in the head. (Regardless of what you use - put anti-seize on the threads when you install them).

Title: Re: Exaust Bolts
Post by Kris01 on 10/03/16 at 18:49:53

Anti-seize and a 1/4" ratchet. Tighten finger tight (or just tight enough to seal). You don't crank 'em down like a head bolt. Recheck for leaks in a few hundred miles.