SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> highway foot pegs
/cgi-bin/YaBB.pl?num=1475413743

Message started by petervt on 10/02/16 at 06:09:03

Title: highway foot pegs
Post by petervt on 10/02/16 at 06:09:03

Can anyone recommend a foot rest that will clamp to the bike frame and fit around the muffler I have 2006 s40 petervt

Title: Re: highway foot pegs
Post by Bobber on 10/02/16 at 18:12:28

I tried the factory engine guard option but it didn't work out too well. I ended up making a custom bar. The factory guard was too close and the pegs up to high.

Title: Re: highway foot pegs
Post by Job on 10/02/16 at 20:11:38

Peter, I found a set of highway pegs that fit the S40 perfectly. They are made by Rivco and run about $170. I have had mine 6 months and I love them.You can get them from J&P, and most of the other large Motorcycle parts places. For the S40 you must have the units for a 1 1\8" frame tube. See picture. Good luck. Jeff

Title: Re: highway foot pegs
Post by RaleighGuy on 10/03/16 at 04:53:09

Jeff, They look really slick. I may just have to put those pegs on my Christmas wish list. ;D

Title: Re: highway foot pegs
Post by Kenny G on 10/03/16 at 06:02:26

Jeff,

Where did you purchase the mudflap that is on the front fender?

Kenny

Title: Re: highway foot pegs
Post by justin_o_guy2 on 10/04/16 at 06:49:17

What did you do to keep airflow to the rectifier?

Title: Re: highway foot pegs
Post by Job on 10/04/16 at 19:57:38

Kenny, I made it from 1/8" thick rubber gasket material and a Sturgis pin I had. JOG The bag crossover fits just behind the regulator and doesn't seem to block the airflow. .

Title: Re: highway foot pegs
Post by Tuck on 10/29/16 at 12:56:12

Looking for help with engine guards for my 2011 Suzuki. I bought a set on Ebay assured they would fit my bike. They did but are too narrow to take the hit should the bike fall (!) I corresponded with the Suzuki plant in Ontario and no one could or would give me the measurements of Suzuki engine guards part # 990A0-73001. Does any one know how wide these guards are? Alternatively, if you have custom welded an extension onto existing bars what does your solution look like? Is extension of a too narrow guard another reason for foot pegs? Thanks, all.

Title: Re: highway foot pegs
Post by Mr.T on 10/29/16 at 13:58:55

Tuck, here is a set I have up for sale - maybe you can use this pic for ideas?

Title: Re: highway foot pegs
Post by Tuck on 10/29/16 at 17:46:30

Thanks, Mr T