SuzukiSavage.com /cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Need some wisdom counterbalance gear tolerance /cgi-bin/YaBB.pl?num=1475046351 Message started by Witchdoctor on 09/28/16 at 00:05:50

Title: Need some wisdom counterbalance gear tolerance Post by Witchdoctor on 09/28/16 at 00:05:50 Hello I haven't been active here just getting my bike together finally. Crank roller bearing and counter balance bearings were shot. Bike has about 19k miles if I remember right.. Put the cases back together tonight and I might be highly paranoid but the gears on the counterbalance/crank make a slap at top dead center and have a hair of freeplay.. They are kind of dry so that might be part of it.. Wondering if there is a way for me to measure the tolerance on them before I go any further?... :(   Don't know if anyone have warn them out of spec before or if that's even possible they seem super strong?  :-? Would suck moose wiener if they need to be replaced I gotta wrestle that crank nut off and all that fun stuff again.  :'(

SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved.