SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Ryca CS-1 Sidestand Bracket dimensions? Anyone?
/cgi-bin/YaBB.pl?num=1468718229

Message started by trevorw on 07/16/16 at 18:17:09

Title: Ryca CS-1 Sidestand Bracket dimensions? Anyone?
Post by trevorw on 07/16/16 at 18:17:09

Hello!! I am pretty much at the end of my build and the one thing doging me is the cs-1 sidestand bracket, if any Ryca cs1 kit owners out there have some spare time and would not mind snapping a few pics of theirs and letting me know the measurements it would be greatly appreciated!
Thanks again thumpers!!

Title: Re: Ryca CS-1 Sidestand Bracket dimensions? Anyone
Post by Dave on 07/17/16 at 07:18:42

The RYCA kick stand mount would be a difficult piece to make....it has quite a bit of machining on it, and it also has a flat piece that crosses over to the opposite side under the engine to add stability.

I can take a picture of it mounted on my bike - but measuring and drawing the darn thing up would take a very long time.......and I went ahead and bought their mount, as I don't have a milling machine.

Title: Re: Ryca CS-1 Sidestand Bracket dimensions? Anyone
Post by trevorw on 07/17/16 at 08:43:06

Thank you that would be awesome!
I was just going to make up a cad drawing and send it to my guy.
I got laid off in May and just can not justify spending $300, which for me after exchange and shipping would prob be close to $500, I managed to make pretty much everything myself so far including the rearset bracket but I know what you mean about this one being tricky!
Thanks again

Title: Re: Ryca CS-1 Sidestand Bracket dimensions? Anyone
Post by Dave on 07/18/16 at 10:22:22

My bracket is already on the bike. The RYCA site has photos that are probably better than I can do with my crappy camera or phone.

http://shop.rycamotors.com/sidestand_mount.html

This strap goes onto the sidestand mount, and then bolts to the other side of the frame to help stabilize the mount and transfer some of the load.

http://shop.rycamotors.com/sidestand_strap.html

I bought RYCA's mount, and made my own strap as shown here.

http://suzukisavage.com/cgi-bin/YaBB.pl?num=1358099938/30

Title: Re: Ryca CS-1 Sidestand Bracket dimensions? Anyone
Post by trevorw on 07/24/16 at 12:04:48

Awesome thanks!

1F24293E2F23383E252D203F4C0 wrote: