SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Front footpeg torque spec?
/cgi-bin/YaBB.pl?num=1468275145

Message started by Redryder652 on 07/11/16 at 15:12:25

Title: Front footpeg torque spec?
Post by Redryder652 on 07/11/16 at 15:12:25

I tightened the front right footpeg mounting nuts that hold the exhaust shield to about 30 ft-lb. Is this right?

I don't want to crush the case...

Title: Re: Front footpeg torque spec?
Post by Dave on 07/11/16 at 18:42:04

I could look it up for you....but then the next time you need to tighten something you would have to ask again

Go to the Tech Section of this forum, look up the Table of Contents, and find the chart for the torque specs.

Title: Re: Front footpeg torque spec?
Post by Redryder652 on 07/11/16 at 18:45:23

59626F7869657E78636B66790A0 wrote:

Ahh... Well I feel dumb now. Didn't know there was a torque spec page and here I am asking all the time... Well thank you for the feedback.

Title: Re: Front footpeg torque spec?
Post by Kris01 on 07/11/16 at 18:56:51

http://suzukisavage.com/cgi-bin/YaBB.pl?num=1098848534

I've been through the Tech section a bazillion times. I don't think I ever opened that page! :-[

Title: Re: Front footpeg torque spec?
Post by Dave on 07/12/16 at 03:16:02

784F4E58534E4F581C1F182A0 wrote:

Ahh... Well I feel dumb now. Didn't know there was a torque spec page and here I am asking all the time... Well thank you for the feedback.

No need to feel dumb......just feel enlightened!

Title: Re: Front footpeg torque spec?
Post by Tocsik on 07/12/16 at 05:56:04

I keep that chart in a plastic sleeve attached to the outside of my tool chest with a magnetic clip. Along with a couple torque conversion charts.