SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Head Intake Pipe (flange) SCREW specs?
/cgi-bin/YaBB.pl?num=1460828845

Message started by DesertRat on 04/16/16 at 10:47:24

Title: Head Intake Pipe (flange) SCREW specs?
Post by DesertRat on 04/16/16 at 10:47:24

anyone know what the specs are for the Head Intake Pipe (flange) SCREWS?

Mine keep backing out and the left side is a b!@tc# to get to without removing the carb. I want to swap them out for stainless steel socket head cap screws for easier access.

47: SCREW OEM part # 02112-1620B

Title: Re: Head Intake Pipe (flange) SCREW specs?
Post by Kris01 on 04/16/16 at 11:16:08

Can't help ya with specs but would threadlocker do you any good?

Title: Re: Head Intake Pipe (flange) SCREW specs?
Post by DesertRat on 04/16/16 at 12:11:27

Kris,

BLUE loctite should remedy the issue, but these are JIS screws, I'm replacing every one of those b@$t@rds

*for the difference in Loctite colors -
http://us.henkel-adhesives-blog.com/post/All-About-Threadlockers/The-Difference-Between-Red-Blue-Green-and-Purple-Threadlockers/

Title: Re: Head Intake Pipe (flange) SCREW specs?
Post by Kris01 on 04/16/16 at 14:48:46

Yeah, the JIS screws can be a PITA! Pull one out, take it to Home Depot and use their thread checker thingy. I always thread a nut on the original and use the same nut on a replacement to make sure I'm buying a duplicate.

Title: Re: Head Intake Pipe (flange) SCREW specs?
Post by DesertRat on 04/21/16 at 06:31:29

Thursday -BUMP-

for all the members cruising this place only during "work" ...

if you know, please let ME know ...