SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Raptor Installation Question?
/cgi-bin/YaBB.pl?num=1458508509

Message started by hawk41 on 03/20/16 at 14:15:09

Title: Raptor Installation Question?
Post by hawk41 on 03/20/16 at 14:15:09

Installed new Raptor petcock this morning (easy,peasy). After disconnecting the fuel line (split on one end so replaced with new) and disconnecting the vacuum line, I went to the other side of the bike to disconnect the vacuum line and found a loose line attached to the front of the carb, removed it and capped the vacuum tube. You can imagine my surprise when I went to install the new fuel line to find the end of the original vacuum line (the one I thought I had removed) was still there! It attaches to the rear of the carb. So, what line did I remove and where does it attach. Couldn't find this other line pictured in the manual. Help would be appreciated. Thanks :-/

Title: Re: Raptor Installation Question?
Post by verslagen1 on 03/20/16 at 14:29:21

sorry... esp not working. here's a pic what should be hooked up.

http://suzukisavage.com/images/uploaded/CarbLeftweb.jpg
http://suzukisavage.com/images/uploaded/CarbRightweb.jpg

Title: Re: Raptor Installation Question?
Post by verslagen1 on 03/20/16 at 14:39:59

in case you have a california carb...

california carb epa port to the left.
standard vacuum port to the right shown capped.

http://suzukisavage.com/yabb2.2/Attachments/picture1414569930.jpg

Title: Re: Raptor Installation Question?
Post by hawk41 on 03/20/16 at 14:48:30

Thanks! What had me confused is one bowl vent line ran downward behind the plastic side cover while the bowl vent line in question has it's open end curving upward toward the petcock and facing the fuel tank. I will just run it along side the other bowl vent tube, out of the way! :)