SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Turn Signal Switch /cgi-bin/YaBB.pl?num=1458156354 Message started by henneman on 03/16/16 at 12:25:54 |
Title: Turn Signal Switch Post by henneman on 03/16/16 at 12:25:54 After getting my 2006 out of storage the right signal is on and won't cancel. I presume I may have inadvertently pushed the switch over after the putting the cover on and it was stuck there this winter. The left signal works OK. I took the switch housing off the bar and sprayed some lubricant in it, and also at the black plastic external switch. I took the lights out of the signals until I can repair this. It appears the covers were glued on instead of screwed. Will the whole assembly have to be replaced on the left bar to repair this? |
Title: Re: Turn Signal Switch Post by youzguyz on 03/16/16 at 13:31:41 2006 has a hazard switch (4 way flasher) as well. You need to open the connectors going to the switches, and check for proper operation of the switches with an ohm meter. A wiring diagram will be a big help for that. This only goes to 2004, but I think it will do for what you are looking to fix: http://suzukisavage.com/cgi-bin/YaBB.pl?num=1294779818 |
Title: Re: Turn Signal Switch Post by Kris01 on 03/16/16 at 18:24:15 Sounds like a short to me. You may have a loose wire touching somewhere where it shouldn't. |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |