SuzukiSavage.com
/cgi-bin/YaBB.pl General Category >> Rubber Side Down! >> Cable routing /cgi-bin/YaBB.pl?num=1454639712 Message started by bobdog on 02/04/16 at 18:35:12 |
Title: Cable routing Post by bobdog on 02/04/16 at 18:35:12 I don't have a manual handy,does anyone have good pics or tricks for the best routing of throttle cable. I have a slight hang up at full lock turn left. Thanks for any and all ideas ! |
Title: Re: Cable routing Post by Art Webb on 02/04/16 at 19:37:32 My manual recommended, when replacing throttle cable, tying the new on the the old one and pulling it into place with the old one as I pulled it out, worked a treat unfortunately I don'y think you're at a place where that's helpful, aside from next time you replace the cable |
Title: Re: Cable routing Post by verslagen1 on 02/04/16 at 21:44:26 that probably works great if you have a straight cable. |
Title: Re: Cable routing Post by thumperclone on 02/04/16 at 21:47:18 0nly clear pic I have from the ssm is for the 06 from the front looking back down and left of the front brake hose to top of forks cross piece thru the spring retainer l > R @ spring retainer throttle, R sw wire cable,brake hose in the center,L sw wire cable, clutch cable while sitting on bike right side of neck along right side of right frame, clamp just above gas tank rubber along frame to carb |
Title: Re: Cable routing Post by bobdog on 02/04/16 at 22:25:30 Thanks, I'll try that. I may just need a new one. |
Title: Re: Cable routing Post by Art Webb on 02/05/16 at 07:56:37 6C7F6869767B7D7F742B1A0 wrote:
it worked great on the one I bent up in the crash, too, though that was still basically straight for most of it's lenth |
SuzukiSavage.com » Powered by YaBB 2.2! YaBB © 2000-2007. All Rights Reserved. |