SuzukiSavage.com - Print Page

SuzukiSavage.com
/cgi-bin/YaBB.pl
General Category >> Rubber Side Down! >> Spark plug wire size and resistance?
/cgi-bin/YaBB.pl?num=1453685154

Message started by SinglesGoinSteady on 01/24/16 at 17:25:54

Title: Spark plug wire size and resistance?
Post by SinglesGoinSteady on 01/24/16 at 17:25:54

Anybody know what size wire (in mm) and resistance (ohms) to replace our plug wires with ? I need a little longer wire to get better routing to my plug. Rather than replace the coil or try and stick the new wire into the coil, I found a wire splice on Dime City Cycles. I'll get a new plug cap too. I've looked through the manual and searched the forum with no joy. Thanks -Dave

Title: Re: Spark plug wire size and resistance?
Post by Kris01 on 01/24/16 at 19:38:40

I would think our low tech bike wouldn't care too much what you used. Any decent wire of sufficient length should work.

Title: Re: Spark plug wire size and resistance?
Post by justin_o_guy2 on 01/24/16 at 20:41:47

Symptoms?

Dirt accumulates around the plug.
Blow clean first.moo

Title: Re: Spark plug wire size and resistance?
Post by SinglesGoinSteady on 01/29/16 at 08:44:51

No running problems, just a rats nest of wiring u dER the tank on my Ryca. I need more clearance to get to the plug and remove cap more easily.